LK Metrology (DCC)

Metris / LK

Default settings:

Com Port Settings: 9600, N, 8, 1

TCP/IP: 212.240.51.91:1400

SP25

Instructions to register Renishaw scanning probe calibration DLL to make it work with CMM-Manager on 3rd party controllers with scanning probe - Download and install new Scanning SDK .msi here - SP25 - What controllers are supported?

• Related Articles

• Sheffield - SMP / UMP (DCC)

  Models: SMP-300, SMP-350, SMP-400, UMP-360 Connection: Serial / RS-232 *null modem Default settings: 19200, O, 8, 1 (SMP-300/350) 57600, O, 8, 1 (SMP-400) Scanning machines with SMP-400 can communicate at either 57600 or 115200 SP25 Instructions to ...

• I++ / DME (DCC)

  See this post - Renishaw UCC I++ Install Guide - for Renishaw UCC I++ systems.

• Deva Installation and Setup (DCC)

  This article will guide you through the complete installation and setup of CMM-Manager on a Deva DCC system. The DEVA DCC CMM-Manager Installation Guide and a sample Deva System Config file are attached below. New Installations: Important Notice Some ...

• Zeiss / Numerex - Robocon-II (DCC)

  Model: Robocon-II Default settings: 4800, N, 8, 1

• Mitutoyo - UC-400 USB (DCC)

  Models: UC-400 USB ComUC USB Driver Ensure the ComUC USB drivers are properly installed. The drivers may be downloaded from here: ComUC USB Driver Probe Head Controller Serial: The cable connecting to the PHC should be plugged into a serial port ...