GD&T
Position Graphics for Report (OutTol Column)
There are two different position graphics that can be displayed in the OutTol column. These graphics are for True and Bilateral Position reports which can be found in the GD&T section of the Report ribbon bar. To display these graphics they must be ...
GD&T - Composite Position
This Knowledge Base article describes how to configure and report Composite Position using CMM-Manager. For a detailed description of the Composite Position tolerance and how it is properly applied, refer to the appropriate topic in the current ASME ...
True Position of a Cylinder
True Position (Cylinder perpendicular to the axis system) This is how most people think of True Position. It is simply derived from the “offset” of the actual to the nominal. In our example here, we have a tolerance band of +/- 0.025 (TP tolerance of ...
Bilateral True Position of a Slot
Bilateral True Position (Slot actual parallel to slot nominal) This is how most people think of True Position. It is simply derived from the “offset” of the actual to the nominal. In our example here, we have a tolerance band of +/- 0.025 (TP ...