Probe / Tip Management
Create and Edit Calibration Sphere
Before calibrating probe styli, you must define and locate a certified reference sphere in CMM-Manager. Defining the sphere establishes its physical diameter and mounting stem geometry so the software can calculate effective tip sizes and avoid shank ...
Tip Calibration
Tip calibration (also referred to as qualification) is the procedure where a stylus measures a certified reference artifact—typically a precision reference sphere—to determine the stylus ball's effective diameter and the spatial center offsets of the ...
Tip Manager
Tip Manager is the primary control window used to define, calibrate, inspect, and manage all probe tip orientations (A and B angular positions on indexable heads like a PH10, as well as stylus definitions) for your active probe assembly. From this ...
Get Tip
Get Tip is a command that sets or changes the active probe tip orientation (the A and B angular positions on an indexable or motorized probe head, such as a Renishaw PH10) for subsequent measurement steps. What the Command Does When CMM-Manager ...
Get Probe Assembly
The Get Probe Assembly command is an operation used to switch the active probe configuration during part programming or execution. When CMM-Manager encounters a Get Probe Assembly command in the program database, it retrieves the stored calibration ...
Create and Edit Probe Assembly
What is the Probe Assembly Dialog? The Probe Assembly is the combined probe system consisting of the probe head, extension bars, touch probe, and styli elements. The complete geometry is stored in CMM-Manager to calculate collision-free probe paths. ...
Utilizing Various Calibration Sphere Configurations
CMM-Manager provides a comprehensive set of tools for calibrating various probe and sphere combinations. This includes a single stylus, multi-styli such as an offset "dog leg" or full star probe, and the ability to define and utilize both single and ...
Using a Disc tip / probe
It is common to use a "disc" stylus when inspecting parts which contain an "undercut" such as a snap ring groove. Here are some tips on proper usage of disc tips in CMM-Manager. For many technical reasons as well as hardware and calibration ...
Teaching the FCR25 Rack Location
The following steps will calibrate the FCR25 rack location. Repeat as needed for any additional FCR25 racks. Calibrate and select an appropriate tip angle which will be used for docking. The selected angle should be selected such that the A axis of ...
Assigning Probes to Racks
The instructions in this article do not apply to systems utilizing the I++ protocol where racks are managed by UCC Server. Please refer to the appropriate Renishaw user guides available from www.renishaw.com or by pressing F1 for context sensitive ...
Renishaw Star and Knuckle Parameters
The following parameters for Renishaw Star and Knuckle adapters have been verified from Renishaw CAD and physical measurement. Parameters are given in mm and inch. Star (Stylus) Centers A-5000-3627 2mm Star Center A-5000-7610 3mm Star Center Offset ...
Using a cylinder tip / probe
It is very common to use a "cylinder" tip when inspecting thin parts such as sheet metal and molded plastic. Here are some tips on proper usage of cylinder tips. For many technical reasons as well as hardware and calibration requirements outside our ...