UCCAssist-2 error: Security files have been changed without permission

For issues relating to the error message seen below:

This is a known bug and the error message can be resolved by deleting the DefaultMachine.ini file. 

• Related Articles

• Troubleshooting - JogDisplayCsy error when connecting with Direct 2.0

  Please follow the instructions below to resolve the above titled issue: Close CMM-Manager For customers running CMM-Manager versions older than 2021, proceed to step a through c Download the hotfix here - ...

• Reconnect Helmel PMAC controller after Windows Update

  Helmel DCC / PMAC controller Error: PMAC Error 999 - General PMAC Error See attached document from Helmel for help reconnecting PMAC controller after Windows Update.  

• Error getting Machine Data from I++ Server/Timeout

  It has been observed that the CMM-Manager connection with the I++ Server times out and fails to connect in some cases.  One possible reason for this timeout could be due to a large number of tips in UCCServer.  Solution: Several workarounds exist for ...

• Mitutoyo SP25 – best practice and settings for scanning

  Recommended Deflection Values: For calibration: 0.2 - deflection 1 0.5 - deflection 2 Note that longer probes, especially with SM25-3 or SM25-4 modules, may error out occasionally at these values. If this occurs, increase the deflection 1 value to ...

• Installation error on Windows 7 systems

  Note: The following steps only apply to CMM-Manager versions 3.10 and above There is a known installation error that can occur on Windows 7 systems with the installation of the VC Runtime Redistributable. The install will make it about ¾ of the way ...