Renishaw - UCClite, UCClite2 (Manual)

Renishaw - UCClite, UCClite2 (Manual)

Models: UCClite, UCClite2
Notes
This controller is now officially known as the MMI controller.

    • Related Articles

    • Renishaw - UCC T3 Plus (+) / S3 / T5 / I++ (DCC)

      DCC Models: UCClite, UCClite2, UCC1, UCC2, Fusion, T3, T3+, T5, S3, S3+ UCC Suite From Renishaw here. Due to a change in how UCC Server deals with "blocks" of commands, CMM-Manager (and some other brands of inspection software) will not run properly ...

    • Sheffield - MP / SMP (Manual)

      Models: MP30/35/30-II Connection: Serial / RS-232 *null modem Default settings: 9600, O, 8, 1 Some DCC capable controllers use a baud rate of 19200. After a change of baud rate from CMM-Manager Machine Setup, the controller has to be restarted. MP35 ...

    • Mitutoyo - MAG Box (Manual)

      Model: MAG box / MAG-3 Interface / Connection Type: GPIB / iEEE Install NI-488.2 Software from National Instruments GPIB Settings Primary Address: 2 Secondary Address: 96 Note - Primary and Secondary Address can be discovered (in case above values do ...

    • Mitutoyo - UD1 PCI (Manual)

      Model: UD1 PCI Card Install the driver for the UD1 PCI Card - Note: 32 and 64 bit OS supported with CMM-Manager 3.8+ Important note for UD1W.dll file - from install guide: 1. For CMM-Manager to communicate with the UD1 card, the following files are ...

    • Renishaw - UCC Direct 2.0 (DCC)

      This driver has been replaced by Direct 3.0 as of CMM-Manager 2026. It is highly recommended to use 3.0 if available on your installation as 2.0 is considered obsolete and can provide limited support. See below for information about the 3.0 driver ...