Manual Interface - Caliper Designs PCI Card
Support for Caliper Designs PCI card on 64-bit Windows OS was added in version 2021.
To bypass Windows unsigned driver installation issue, please follow the instruction listed in this
KB article.
Related Articles
Mitutoyo - UD1 PCI (Manual)
Model: UD1 PCI Card Install the driver for the UD1 PCI Card - Note: 32 and 64 bit OS supported with CMM-Manager 3.8+ Important note for UD1W.dll file - from install guide: 1. For CMM-Manager to communicate with the UD1 card, the following files are ...
Manual Interface - Deva PCI and USB
Link to Deva Manual Interface Setup Guide - Deva Installation and Setup (Manual)
Manual Interface - TOPMES - AX3 USB
TOPMES AX3 USB Counter Manufactures website - AX3 unit Topmes Datasheet: 16_AX3_DS_2_en.pdf
Mitutoyo - MAG Box (Manual)
Model: MAG box / MAG-3 Interface / Connection Type: GPIB / iEEE Install NI-488.2 Software from National Instruments GPIB Settings Primary Address: 2 Secondary Address: 96 Note - Primary and Secondary Address can be discovered (in case above values do ...
Deva Installation and Setup (Manual)
This article will guide you through the complete installation and setup of CMM-Manager on a Deva Manual system. The DEVA Manual CMM-Manager Installation Guide and a sample Deva System Config file are attached below. New Installations: Important ...