Hexagon (B&S) - Reflex Box / Micro Height 3D (Manual)

Hexagon (B&S) - Reflex Box / Micro Height 3D (Manual)

Model: Reflex Box / Micro Height 3D
Notes
Firmware must be 2.4+ to support pass-through mode for communication to CMM-Manager.



    • Related Articles

    • Hexagon (B&S) - Man3 (Manual)

      Model: Man3 Box

    • Hexagon (B&S) - Sharpe2 (DCC)

      Sharpe2 Default settings: Com Port Settings: 4800, E, 7, 1 If the downl.oad file fails to load, try this: Open C:\ProgramData\QxSoft\CMM-Manager [current version]\Driver\SharpeDriver.ini Find the line: DOWNLOAD_NEW 0 // 0 - old method, 1 - new method ...

    • Hexagon (B&S) - Sharpe32 (DCC)

      Sharpe32 Default settings: Com Port Settings:4800, E, 7, 1 Configuration File: Downl.oad or Syspar.asc file is required. See the install guide for details on the location and usage of these files. Error Map: Comp.dat or Comp.asc file will likely be ...

    • Mitutoyo - MAG Box (Manual)

      Model: MAG box / MAG-3 Interface / Connection Type: GPIB / iEEE Install NI-488.2 Software from National Instruments GPIB Settings Primary Address: 2 Secondary Address: 96 Note - Primary and Secondary Address can be discovered (in case above values do ...

    • Hexagon (B&S) - Leitz / Sharpe32z / RC1 (DCC)

      Models: Leitz, Sharpe32z, RC1 Leitz (Com Port) Default settings: Controller Selection: Leitz Com Port Settings: 9600, N, 8, 1 ProbeType - TP6 Leitz (TCP/IP) Default settings: Controller Selection: Leitz TCP/IP: IP address in the range 80.128.0.X ...