Helmel - Pro Counter II / III(Manual)

Helmel - Pro Counter II / III(Manual)

ProCounter II - works with OS up to Windows XP(32 bit)

ProCounter III - works with newer OS including Windows 7 (32 and 64 bit)



    • Related Articles

    • Helmel - PMAC (DCC)

      Important: Do not plug in the USB device until all drivers and required utilities are installed. If the software fails to connect - i.e., "Failed to open Pmac device 1" - Be sure to run CMM-Manager as Administrator, especially with Windows 7. PMAC ...

    • Reconnect Helmel PMAC controller after Windows Update

      Helmel DCC / PMAC controller Error: PMAC Error 999 - General PMAC Error See attached document from Helmel for help reconnecting PMAC controller after Windows Update.  

    • Sheffield - MP / SMP (Manual)

      Models: MP30/35/30-II Connection: Serial / RS-232 *null modem Default settings: 9600, O, 8, 1 Some DCC capable controllers use a baud rate of 19200. After a change of baud rate from CMM-Manager Machine Setup, the controller has to be restarted. MP35 ...

    • Mitutoyo - UD1 PCI (Manual)

      Model: UD1 PCI Card Install the driver for the UD1 PCI Card - Note: 32 and 64 bit OS supported with CMM-Manager 3.8+ Important note for UD1W.dll file - from install guide: 1. For CMM-Manager to communicate with the UD1 card, the following files are ...

    • Mitutoyo - MAG Box (Manual)

      Model: MAG box / MAG-3 Interface / Connection Type: GPIB / iEEE Install NI-488.2 Software from National Instruments GPIB Settings Primary Address: 2 Secondary Address: 96 Note - Primary and Secondary Address can be discovered (in case above values do ...