Most Discussed Topics
Probe not registering points
Sometimes on the initial touch after the cad alignment the Ph20 will not register the points, and we have to start the cycle over again until it registers. Sometimes it will start to register the points after it missed the first couple. When it does that
No Pathing.
i am having an issue I have never come across. I loaded my CAD model, aligned CAD with machine coordinates. CMM manager will not path from one feature to the next. It will draw the probe points, but start point is just above first hit, and I get a collision
Cross section nominals wrong
I've run into this issue a few times and I'm wondering if I'm doing something wrong when creating new curves from cross sections. This model has just been imported and placed using the Import/Export tools, so has not been influenced/rotated by any manual
Cell formats in Excel from DDE output
I just upgraded to CMM-Manager 2024 and now my dates in Excel are not showing up as formatted. This started happening when I started to use 2024. I have looked in the KB and the Community with no success in finding a solution. The Excel spreadsheet that
Questions on Move Part
If Nate can answer this, I would greatly appreciate it. I have a round flat part that I have to check. Datum B is a diameter; I can access it only on one side. Several holes on the other side (bottom) are called back to Datum B. I realize I can use Move